Select
desired location for the EVERLITE Illuminator and Post assembly
Drive
stake into ground until roll pin is at ground level
Use
a sledgehammer or other large appropriate tool (Fig.
1)
Roll
pin should be in upper left corner (10 o’clock)
when your back is towards the street (Fig. 2)
Try
to drive the stake straight
Place
Illuminator Plate on Yard Post with chamfered hole side
up. Attach with provided slotted screws (Fig. 3).
Place
assembled Illuminator* on Yard Post Plate. Attach with
provided Allen screws and wrench (Fig. 4).
* (See separate assembly instructions contained with the
Illuminator)
Slide
the wire from the power source (collector or Door Bell
transformer) up the Yard Post and through access hole
at the top of the Plate (Fig. 5).
Attach
red wire to the + post (R) and white wire to the - post
(W) with the terminal post screw (Fig. 6). Door Bell powered
units do not have a + post (R) or a - post (W).
Place
Post assembly over stake so the bottom of the yard post
rests on the roll pin. Fasten the yard post to the stake
with the provided slot screw and washer. You will want
to bend down and visually locate the drilled and tapped
hole through the post prior to fastening. It’s makes
it easier to know where you’re going (Fig. 7).
Place
supplied post cap on top of the yard post (Fig. 8).
